WHAT IS THE CUSTOM KEY

Q: How do I use the TLR-7A | TLR-7X, TLR-8, or TLR-7 Sub with our holster?

A: With the Glock 43X MOS and Glock 48 MOS, use the TLR-7 Sub (GL).

A: With any of the RECOVER TACTICAL RAILS, you must use the TLR-7 Sub (1913s) along with our CUSTOM KEY. Will not work with the TLR-7 Sub (GL) / TLR-7 SUB (SIG).

A: With any of the RECOVER TACTICAL RAILS and the TLR-7A , TLR-7X, TLR-7 HL-X or TLR-8, you must use our CUSTOM KEY.

A: With the factory Sig Sauer P365 | P365X and P365-XL grip modules, use the TLR-7 Sub (SIG).

A: With the factory Sig Sauer P365-XMACRO | P365-AXG LEGION | P365-FUSE grip modules, use the TLR-7 Sub (1913s), you must use our CUSTOM KEY. Will not work with the TLR-7 Sub (SIG).

A: With ALL ICARUS PRECISION use the TLR-7 Sub (1913s), you must use our CUSTOM KEY. Will not work with the TLR-7 Sub (SIG).

A: With ALL SHARPS BROS use the TLR-7 Sub (1913s), you must use our CUSTOM KEY. Will not work with the TLR-7 Sub (SIG).

A: With Springfield Hellcat you must use the TLR-7 Sub (SA).

To switch the rail keys on your Streamlight TLR-7 sub

You will need the multi-tool provided with the light or a small flat-head screwdriver. Changing the key allows the light to seat properly in the rail notch of your specific firearm.

1. Initial Preparation

Unload the firearm: Ensure the magazine is removed and the chamber is empty before starting.
Remove from rail: Loosen the rail clamp tension bolt on the side of the light to detach it from the firearm.

2. Remove the Current Key

Fully tighten the bolt: Tighten the rail clamp tension bolt completely to expose the e-clip on the opposite side.
Pop the e-clip: Use the "e-clip" side of your multi-tool to push the open end of the e-clip off the bolt.
Remove the bolt: Completely unscrew and remove the tension bolt. Keep the spring attached to the bolt.
Slide the key out: Remove the movable jaw (the side plate) and slide the current key out of its slot.

3. Install the New MIE Productions Custom Key

Insert the key: Place the new key into the slot between the movable and fixed portions of the clamp.
Reassemble the bolt: Pass the tension bolt through the fixed side, the new key, and into the movable side.
Secure the e-clip: Tighten the bolt fully, then use the "insert" side of the multi-tool to snap the e-clip back into the groove on the bolt.